I have a SS10. 
Trying to get NetBSD installed on it.

I boot up with disk1.fs
Everything is fine until it asks for the second one.
I insert disk2.fs and get this:

Floppy device to load the installation utilities from [/dev/rfd0a]:
Extracting installation utilities...
fd0a: hard error reading fsbn 0
fd0: controller status: state 17 (st0 70<abnrml,seek_cmplt,drv_chck> cyl
0)
fd0a: hard error reading fsbn 0 of 0-127
fd0: controller status: state 17 (st0 70<abnrml,seek_cmplt,drv_chck> cyl
0)
tar: End of archive volume 1 reached

ATTENTION! tar archive volume change required.
Ready for archive volume: 1 
Input archive name or "." to quit tar.
Archive name >



That's what I get.
I've tried entering into this prompt. 
Nothing seems to work. No matter what i type it gives me :
tar: Failed open to read on <whatever i enter> <No such file or directory>
gzip: standard input is a terminal -- ignoring 
Cannot open <whatever i enter>, try again.


Help me out here.
I've tried remaking the boot floppy several times.
And i've also tried renaming the file to someting tar would recognize .gz
or .tgz . 


I've tried making the floppies myself. 
But the information i found in the FAQ was wrong.

Can anyone help me debug this further please ? 
Or atleast point me to the right docs on howto make boot floppies. 


thanx.

- DAFT PUNK ARE ROBOTS !