Hi all,
I was able to install netBSD onto my Sparc1+ but after the installation I'm
not able to boot into netBSD.  Here are a couple of the things I've tried
1) both boot sd(0,1,0)
	and bood sd()
	but I get a message that both of those commands are outdated.
2) so I try "boot disk" but for some reason it says "can't open device" at
target sd3,0
If I probe-scsi the hard disk I want to boot off is at scsi 1
I think that if you "boot disk" it looks at scsi port 3.  I have the env
argument boot-file set to netbsd.
I apologize if this seems to ramble, but any ideas on where to go from here?
-Andy