Hi, I have two monitors, one with 5 bnc, and one with 13W3 on it. I'm not 
getting a console at all on the monitor with the 13W3 connector. So, I 
chopped the cable, and just ran the red green and blue signal lines to 
three BNC connectors. Then hooked it up to my 5BNC monitor which supports 
sync on green. I can just barely see the console if I crank the 
brightness and contrast up to 100%, so my question is, is there some type 
of software or hardware controlled brightness setting on the card? I have 
a type 6 keyboard that has brightness buttons on it, but they just produce 
"Unknown scancode" errors on the console. do I have a bad frame buffer, 
bad cable or am I just an idiot? I know it is nothing wrong with the 
monitors, both work fine when connected to other machines.

-- 

The nice thing about Windows is - It does not just crash, it displays a
dialog box and lets you press 'OK' first.
						-- Arno Schaefer