Hi all.

This is probably old news, but I didn't see anything in the archives...

I'm trying to load 1.6.2 on an IPX using the miniroot.fs dumped to a  
swap partition.

If I have an sbus HME 100Mb ethernet card in, it panics and I get no  
further.  I can't verify that this hme card is good, but it "should"  
be.

I know some other *bsds don't support the hme on sun4c due to prom  
issues, but I didn't see anything in the hardware lists to indicate  
this on netbsd.

One complication: the IPX does have a dead NVRAM which is awaiting  
replacement, but for the moment it will boot if I completely remove the  
NVRAM (though with foolish MAC).  Will replacing the module fix this?

dmesg:

ok boot disk:b netbsd -s

Rebooting with command: disk:b netbsd -s
Boot device: /sbus/esp@0,800000/sd@3,0:b   File and args: netbsd -s
 >> NetBSD/sparc Secondary Boot, Revision 1.12
 >> (autobuild@tgm.netbsd.org, Wed Feb 11 07:53:48 UTC 2004)
Booting netbsd
2848712]=0x36dd24
OBP version 2, revision 2.3 (plugin rev 2)
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003

     The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
     The Regents of the University of California.  All rights reserved.


NetBSD 1.6.2 (GENERIC) #0: Wed Feb 11 08:05:11 UTC 2004

      
autobuild@tgm.netbsd.org:/autobuild/netbsd-1-6-PATCH002/sparc/OBJ/ 
autobuild/netbsd-1-6-PATCH002/src/sys/arch/sparc/compile/GENERIC

total memory = 65376 KB
avail memory = 60180 KB
using 128 buffers containing 512 KB of memory
bootpath: /sbus0/esp@0,800000/sd@3,0:b
mainbus0 (root): SUNW,Sun 4/50
cpu0 at mainbus0: cache chip bug; trap page uncached: W8601/8701 or  
MB86903 @ 40 MHz, on-chip FPU
cpu0: 64K byte write-through, 32 bytes/line, hw flush: cache enabled
memreg0 at mainbus0 ioaddr 0xf4000000
clock0 at mainbus0 ioaddr 0xf2000000: mk48t02: hostid a0a0a0a0
timer0 at mainbus0 ioaddr 0xf3000000 ipl 10: delay constant 17
auxreg0 at mainbus0 ioaddr 0xf7400003
zs0 at mainbus0 ioaddr 0xf1000000 ipl 12 softpri 6
zstty0 at zs0 channel 0 (console i/o)
zstty1 at zs0 channel 1
zs1 at mainbus0 ioaddr 0xf0000000 ipl 12 softpri 6
kbd0 at zs1 channel 0: baud rate 1200
ms0 at zs1 channel 1: baud rate 1200
audioamd0 at mainbus0 ioaddr 0xf7201000 ipl 13 softpri 4
audio0 at audioamd0: full duplex
sbus0 at mainbus0 ioaddr 0xf8000000: clock = 20 MHz
dma0 at sbus0 slot 0 offset 0x400000: dma rev 1+
esp0 at sbus0 slot 0 offset 0x800000 level 3: ESP100A, 20MHz, SCSI ID 7
scsibus0 at esp0: 8 targets, 8 luns per target
le0 at sbus0 slot 0 offset 0xc00000 level 5: address fe:fe:fe:11:11:11
le0: 8 receive buffers, 2 transmit buffers
hme0 at sbus0 slot 2 offset 0x8c00000 level 4 (ipl 5): Sun Happy Meal  
Ethernet (SUNW,hme)
hme0: Ethernet address fe:fe:fe:fe:fe:fe
async mem arr: ser=0 sva=0xffe70000 aer=20<TIMEOUT> ava=0xfe02a00c
parity error register = 0
panic: memory error
halted


Program terminated
Type  help  for more information
ok