Re: SUNW,m46B resolutions?

[der Mouse <mouse%Rodents-Montreal.ORG@localhost>]

>> How?  I'm not familiar with any interface that allows changing a
>> framebuffer's resolution after booting.  I even had a quick look at
>> the driver and didn't see anything.  What should I go read up on?
> i don't know much about this, but are you looking at netbsd 3.1
> sources you're missing out on the last 44 revisions to machfb.c.

"machfb.c since rev 1.xx" is a perfectly reasonable answer.

Actually, I wasn't looking at the 3.1 source; I was looking at 4.0.1,
that being the most recent I had at ready hand: machfb.c 1.48.2.1.4.1.

Come to think of it, I know where to find unpacked 5.1 source, too.  I
just now diffed that machfb.c against 4.0.1's and see nothing that
looks relevant, so, either it's newer than 5.1 or I'm still missing
something.  While I'm not _ignoring_ the possibility of the former, I
currently consider the latter more likely.

/~\ The ASCII                             Mouse
\ / Ribbon Campaign
 X  Against HTML                mouse%rodents-montreal.org@localhost
/ \ Email!           7D C8 61 52 5D E7 2D 39  4E F1 31 3E E8 B3 27 4B