On Wed, Jan 09, 2019 at 07:03:11PM +0900, Christian Rodriguez wrote:
The following values show up during detection of the SCSI HBA and drive:
"*0x12000", "0x22000", "0x52000", "0x62000", "0x72000", and "0x82000"*.
Then, after detection it starts spamming a ton of messages with values like
*"0x952000", "0x992000", "0x9a2000", "0xa52000", *etc. It seems to just be
incrementing upward.
Any idea what this could be about? I'm really curious.
This decodes into:
type seq cmd
0x012000 1 1 0
0x022000 1 2 0
0x052000 1 5 0
0x062000 1 6 0
0x072000 1 7 0
0x082000 1 8 0
0x952000 1 0x95 0
0x992000 1 0x99 0
0x9a2000 1 0x9a 0
0xa52000 1 0xa5 0
where type = 1 means scsi initiator.
This means that in the list of open commands, the first command (all or your
values had cmd = 0) does not match the response from the device.
I have changed the error message to give better diagnostics. Could you
retry when the next autobuild is available?
Thanks,
Martin