On Thu, 16 Dec 2004, George Harvey wrote:

> With the CMD card installed, I get exactly the same output. If I then
> remove the TK70 controller, I still get the same output! From this I
> guess that my CMD card is configured with the same address as the TK70
> controller. I've had a hunt on the 'net but haven't found any info on
> jumper settings for the CQD-223 so I'm looking for help to re-jumper it
> to a non-overlapping address.

http://www.bitsavers.org/pdf/cmd/CQD-220_CQD-223_Nov90.pdf

I used address 772150.

-- 
Kirk Russell            <kirk@ba23.org>            http://www.ba23.org/
Bridlewood Software Testers Guild                  Ottawa Ontario Canada