Subject: Large Disks (>4GB) in VS4000/90A: Works fine
To: None <port-vax@netbsd.org>
From: Matt Thomas <matt@3am-software.com>
List: port-vax
Date: 04/08/2005 20:08:37
I finally around to putting in one of idle 18GB 50pin disks. Both the
VS4000 firmware and NetBSD are happy it.
>>> show config
KA49-A V1.4-0D0-V4.4 83 MHZ
08-00-2B-BF-46-25
128MB
DEVNBR DEVNAM INFO
------ -------- --------------------------
1 NVR OK
3 DZ OK
4 CACHE OK
5 MEM OK
128MB 0A,0B,0C,0D=16MB, 1E,1F,1G,1H=16MB
6 FPU OK
7 IT OK
8 SYS OK
9 NI OK
10 SCSI OK
4-L0-DNES-31 7-INITR
11 AUD OK
13 TCA OK
NO OPT PRES v1.0
>>> show dev
VMS/VMB ADDR DEVTYPE NUMBYTES RM/FX WP DEVNAM REV
------- ---- ------- -------- ----- -- ------ ---
EZA0 08-00-2B-BF-46-25
DKA400 A/4/0 DISK 18.35GB FX DNES-31 SA30
..HostID.. A/7 INITR
NetBSD 3.99.3 (VS4K) #2: Fri Apr 8 15:42:10 PDT 2005
matt@zippy.home:/u1/kobj/vax/VS4K
MicroVAX 4000/90
cpu0: KA49
total memory = 127 MB
avail memory = 121 MB
mainbus0 (root)
vsbus0 at mainbus0
vsbus0: 8K entry DMA SGMAP at PA 0x27000000 (VA 0x8b063000)
vsbus0: interrupt mask 0
ze0 at vsbus0 csr 0x20008000 vec 410 ipl 15 maskbit -1
ze0: hardware address 08:00:2b:bf:46:25
dz0 at vsbus0 csr 0x25000000 vec 524 ipl 15 maskbit 3
dz0: 4 lines
asc0 at vsbus0 csr 0x26000080 vec 510 ipl 15 maskbit 1
asc0: NCR53C94, 25MHz, SCSI ID 7
scsibus0 at asc0: 8 targets, 8 luns per target
scsibus0: waiting 2 seconds for devices to settle...
sd0 at scsibus0 target 4 lun 0: <IBM, DNES-318350, SA30> disk fixed
sd0: 17501 MB, 11474 cyl, 10 head, 312 sec, 512 bytes/sect x 35843670 sectors
sd0: sync (160.00ns offset 15), 8-bit (6.250MB/s) transfers, tagged queueing
boot device: sd0
root on sd0a dumps on sd0b
root file system type: ffs
--
Matt Thomas email: matt@3am-software.com
3am Software Foundry www: http://3am-software.com/bio/matt/
Cupertino, CA disclaimer: I avow all knowledge of this message.