Re: VAXstation 4000/90 help

[John Klos <john%ziaspace.com@localhost>]

> Hum. I'd check the switch for a bad connection or something then. If the LEDs 
> are changing, there should be output on the console.

The LEDs only change once, and only once again if the halt button is 
pressed.

> If not, then it's either directed to the wrong console, or else you have a 
> broken serial port.
> (I assume you are using the right port on the VAX, that your cable is ok, and 
> that you have a terminal connected that aren't messing you up with some weird 
> opinions (or a computer with some program connecting you to a serial port).

It's the same setup I use for one of my 4000/60, so I know the machine I'm 
running cu on is fine and I know the cable is good.

> There is a lot of serial port debugging that can be done, but it is so much 
> depending on what you observe, and so on, that it's hard to write a general 
> checkup.

Part of the problem is that I don't get anything at all on the serial...

Thanks,
John