Hi Thomas,
How far did you get?
It has been a while since I have hopped on the port-vax mailing list, and I was hoping that you got the answers you were looking for.
I have a VAX 4000-200 with the KFQSA controller looped into the onboard DSSI bus and it is booting my 3 local drives just fine.
I had to change the controller ID for the SHAC to 6 as you can't have the onboard and the KFQSA at the same address. But I have it booting NetBSD 9.0 and I am trying to build 10.0 release now.
I can send pictures of the setup if you need them.
Here is my DSSI bus setup.
DSSI ID
On 2024-01-02 20:08, thomas dzubin wrote:
I know NetBSD does NOT support the SHAC DSSI controller on the KA660
CPU cards, but if I take a KFQSA controller from one of my other VAX,
can the chassis "internal" DSSI disks be disconnected and then
re-connected to the KFQSA card bypassing the SHAC chips on the CPU
card?
I've got a couple of VAX 4000-200 boxes, but they only run OpenVMS
now, but I'd like to install NetBSD on them.
has anyone tried this?
Happy 2024 everyone,
Thomas Dzubin
Calgary, Vancouver, and Saskatoon