Module Name:	src
Committed By:	dyoung
Date:		Mon Dec 20 23:05:42 UTC 2004

Modified Files:
	src/sys/dev/ic: rtw.c rtwphyio.c rtwreg.h rtwvar.h

Log Message:
Realtek sample sources are not consistent about the "Digital PHY"
bit in the SROM.  It seems as if it is set to 1 when the PHY is
*analog*, not *digital*.  Fix my sources.

In rtw_intr_rx, use units of 500kb/s instead of 100kb/s for rate,
to be consistent with net80211's expectations.  Polish up some
debugging ugly messages.  Dump raw 802.11 packets if IFF_DEBUG|IFF_LINK2
and RTW_DEBUG is defined.

Polish power-state (on/sleep/off) handling.  Especially improve
support for RFMD (totally untested) and Maxim.  For Philips, take
the Digital PHY property into account.

Call the net80211 watchdog function from rtw_watchdog, so that we
scan again if auth/assoc fails.

Be a little more cautious about writing register[RTW_TPPOLL], since
other drivers are....  Don't frob the high/low-priority queues
right now, since I don't use them.

Add rtw_join_bss which programs the card with the BSSID and other
properties of a BSS.  Use it on state transitions.  Factor out
rtw_set_nettype.

Make rtw_recv_beacon call ieee80211_recv_mgmt instead of dropping
beacons on the floor!  TBD IBSS merges.

Change some rtw_debug=2 printfs to rtw_debug=3 (RTW_DPRINTF3)
printfs so the console doesn't get spammed so badly at rtw_debug=2.
Change some debugging printfs to RTW_DPRINTFs.  E.g., print the
"RF programming method" only if debugging is enabled.


To generate a diff of this commit:
cvs rdiff -r1.9 -r1.10 src/sys/dev/ic/rtw.c
cvs rdiff -r1.2 -r1.3 src/sys/dev/ic/rtwphyio.c src/sys/dev/ic/rtwreg.h
cvs rdiff -r1.5 -r1.6 src/sys/dev/ic/rtwvar.h

Please note that diffs are not public domain; they are subject to the
copyright notices on the relevant files.