hubert@feyrer.de wrote:

> src/distrib/utils/sysinst/arch/{hp300,mvme68k,x68k}/md.c's 
> md_cleanup_install() claims that it can't run enable_rc_conf(), as "sed is 
> too large for the ramdisk" (comments).
> 
> I've changed sysinst to use the newly installed system's sed(1) instead 
> now, see rev. 1.144 of src/distrib/utils/sysinst/util.c.
> 
> I wonder if there's some good reason to not run enable_rc_conf() on any of 
> these platforms now? I cannot test this though, could you?

No port specific reason for hp300 (and it was written before I took over
the port-master's role), but I often wonder why network isn't configured
during sysinst if we install sets from a local disk and whether it's okay
to say "configured."
---
Izumi Tsutsui