On Jun 26, 2005, at 12:19 PM, Christos Zoulas wrote:
> Are the two interfaces connected to the same type of switches? Could it
> be that the switch is causing the problem to the internal interface?

That was a possibility I had considered.  The fxp0 interfaces are on a 
seperate
hardware switch from the fxp1.  Remember the 'port assertion' problem 
in 1.6.0
about two years ago when a CS20 could effectively lock up an entire 
switch?

I'll get the details on the cisco ethernet switches I'm using and their 
differences in
configuration.  Another thing to note is that I ran these all on 1.6.x 
for 2+ years
with only minimal SCB timeout issues .. it was never this frequent.  
The only thing
that has changed is I moved all the systems from 1.6.x to 2.0.2 in a 
single event.

The DS10Ls which don't use fxp (they're tulip) use the same switches 
for front end
and back end traffic and run very well.