Re: How to hot swap an SCA SCSI disk with NetBSD

[Mouse <mouse%Rodents-Montreal.ORG@localhost>]

>> SCA is just a type of connector.  As far as I know, there are no
>> extra signals (in particular there is no way to signal the OS that
>> the device was removed).
> That's true, but, generally, SCA backplanes are intelligent devices
> which can report device insertion/removal to the host over the SCSI
> bus - see ses(4).

The backplane still has to notice it somehow.

Also, "generally" is, I suspect, an artifact of the hardware you've
worked with.  Most of my SCA equipment is not that smart - the SS20,
for example, uses SCA but has nothing of the sort as far as I can tell.

To get back on the original subthread, I wouldn't want to connect or
disconnect a load from a bus that's got live operations going on it;
for hot-swap, I'd expect switching electronics that does the
disconnect/reconnect before/after the electrical contact is
broken/made, and timed to not disrupt a transfer in progress.  Either
that or I'd use bidirectional buffer logic, so there is nothing like a
direct electrical connection between the SCA pins and the SCSI bus.

/~\ The ASCII                             Mouse
\ / Ribbon Campaign
 X  Against HTML                mouse%rodents-montreal.org@localhost
/ \ Email!           7D C8 61 52 5D E7 2D 39  4E F1 31 3E E8 B3 27 4B