Thanks for the suggestions! I tried to do the modification (just manually since it's two lines) and it does show up as 1 in the dmesg, but no dice. dmesg from my laptop since it was easier, this uhub2 is on an ehci bus: [ 188.679957] umass0 at uhub2 port 2 configuration 1 interface 0 [ 188.679957] umass0: NXP (0x1fc9) LPC1XXX IFLASH (0x000b), rev 2.00/7.04, addr 4 [ 188.679957] umass0: using SCSI over Bulk-Only [ 188.679957] scsibus0 at umass0: 2 targets, 1 lun per target [ 188.679957] sd0 at scsibus0 target 0 lun 0: <NXP, LPC1XXX IFLASH, 1.0> disk removable [ 188.679957] sd0: fabricating a geometry [ 188.679957] sd0: 34816, 1 cyl, 64 head, 32 sec, 512 bytes/sect x 68 sectors [ 188.689958] autoconfiguration error: sd0: unable to open device, error = 5 roadwarrior# fdisk sd0 fdisk: cannot opendisk /dev/rsd0: Input/output error roadwarrior# disklabel sd0 disklabel: /dev/rsd0: Input/output error roadwarrior# mount -t msdos /dev/sd0d /mnt mount_msdos: /dev/sd0d on /mnt: Input/output error I also tried the start command mlelstv@ suggested, but alas: roadwarrior# scsictl sd0 start scsictl: sd0: Input/output error and for good measure: roadwarrior# scsictl scsibus0 reset scsictl: SCBUSIORESET: Inappropriate ioctl for device roadwarrior# scsictl scsibus0 scan 0 0 roadwarrior# scsictl scsibus0 scan 1 0 (nothing new in dmesg) Staffan
Attachment:
OpenPGP_signature.asc
Description: OpenPGP digital signature