I have now enabled acphy and ukphy in the kernel but it still doesnt work. 
Enabling acphy made the "not configured"-messages to dissapear,
but nothing more. Still down have any link light, but when i connect/
disconnect the cable from the ether port status in ifconfig changes between 
active and "no carrier".

After leting this device being connected to a network for some time,
the console startet to show these messages in a "loop fashion":

<CUT>
aue0: 248 usb errors on rx: IOERROR
aue0: 250 usb errors on rx: IOERROR
aue0: 249 usb errors on rx: IOERROR
</CUT>

Very irritating, so i disconnected the D-Link adapter. The kernel
than went into debugmode (db>) with the following message:

<CUT>
usb_detach_wait: aue0 didn't detach
aue0 detached
uvm_fault(0xc03c56c0, 0x0, 0, 1) -> e
kernel: page fault trap, code=0
Stopped in pid 3 (usbtask) at usbd_free_xfer+0x24: movl 0x2c(%eax), %eax
</CUT>

Suggestions what can be wrong ?


Regards ...
Ivar


>From: "Nathan J. Williams" <nathanw@wasabisystems.com>
>To: "Ivar Skjoerseter" <ivarhs@hotmail.com>
>CC: tech-net@netbsd.org, dillema@pasta.cs.uit.no
>Subject: Re: aue device problem
>Date: 14 Nov 2002 16:18:11 -0500
>
>"Ivar Skjoerseter" <ivarhs@hotmail.com> writes:
>
> > I have a problem getting my D-Link USB Fast Ethernet DU-E100
> > adapter to work. The device is detected and I can use ifconfig
> > to both show information and configure addresses, but i can't
> > get link. Anybody experienced the same problem ?
> >
> > According to my 'dmesg' i get this message that is probably
> > important, but i have the same message after my fxp0 interface
> > wich works fine:
> >
> >    OUI 0x0010a9 model 0x0001 rev 0 at aue0 phy 1 not configured
>
>You need "acphy* at mii? phy ?" in your kernel config, or
>"ukphy* at mii? phy ?" as a fallback.
>
>         - Nathan


_________________________________________________________________
The new MSN 8: smart spam protection and 2 months FREE*  
http://join.msn.com/?page=features/junkmail