Re: ikphy negotiation problem with cisco

[Manuel Bouyer <bouyer%antioche.eu.org@localhost>]

On Wed, Mar 31, 2010 at 08:34:52PM +0000, john heasley wrote:
> I have a new board (Supermicro X7DVA-8/X7DVA-E) with a dual interface
> as indicated below.  The problem is that this interfaces refuses to
> auto-negotiate with a cisco 6500 gige port.  The only way to get link
> is auto-neg on the wm and hard-configured 100m/half duplex.
> 
> Does anyone have this mac / phy combination that is working?

I have several of this one:
wm0 at pci4 dev 0 function 0: i80003 dual 1000baseT Ethernet, rev. 1
wm0: interrupting at ioapic0 pin 18, event channel 6
wm0: PCI-Express bus
wm0: 65536 word (16 address bits) SPI EEPROM
wm0: Ethernet address 00:30:48:31:43:82
ikphy0 at wm0 phy 1: i82563 10/100/1000 media interface, rev. 2
ikphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 
1000baseT-FDX, auto

It negociates properly with a 100baseTX or 1000baseT port of a
cisco 3750 serie switch.
This is with a netbsd-5 kernel, sources around the 17 March

-- 
Manuel Bouyer <bouyer%antioche.eu.org@localhost>
     NetBSD: 26 ans d'experience feront toujours la difference
--