Re: ral driver is not working

[HugLeo <hugocanalli%gmail.com@localhost>]

Hi.

I don't need use wpa or wep. My ISP filter by MAC Addresses.

On Mon, May 11, 2009 at 3:04 PM, Francisco Valladolid 
<ficovh%gmail.com@localhost> wrote:
> Hi,
>
> Are you using wpa or wep authentication ?
>
> for WEP :
>
> # ifconfig ral0 nwid <my_ap> nwkey 0x1234567890
> # dhcpcd ral0
>
> for WPA, WPA2 it can do via wpa_supplicant
>
> Create or edit /etc/wpa_supplicant.conf
>
> ctrl_interface=/var/run/wpa_supplicant
> ctrl_interface_group=wheel
>
> network {
> ÂÂÂÂÂ ssid=myhomewlan
> ÂÂÂÂÂ scan_ssid=1
> ÂÂÂÂÂ key_mgmt=WPA-PSK
> ÂÂÂÂÂ psk="some_wpa_key"
> }
>
> then initi wpa_suppplicant
>
> # wpa_supplicant -iral0 -B -c/etc/wpa_supplicant.conf
>
> for wpa key, you can use
> wpa_passphrase(8)
>
> Best Regards.
>
>
>
>
>
> On Tue, May 5, 2009 at 9:34 PM, HugLeo <hugocanalli%gmail.com@localhost> 
> wrote:
>>
>> Hi
>>
>> I'm using a PCI D-Link DWL G510 (Ralink Chipset). NetBSD detect like ral0
>> and I can set options, by instance:
>>
>> ifconfig ral0 192.168.1.2 nwid MyNetwork
>>
>> But I get no network.
>>
>> I also use:
>> wiconfig ral0 -D
>> But detect no access point.
>>
>> I've tried use wpa_supplicant with ap in monitor mode but I also don't get
>> success.
>>
>> dmesg detect: ral0 at pci 1 dev 9 function 0: vendor 0x1814 product 0x0302
>> ral0 interrupting at ioapic 0 pin 17
>> ral0 MACIBBP RT2561C, RF RT2527
>>
>> Any ideas?
>> --
>> -hUgLeO-â
>
>
>
> --
> Francisco Valladolid H.
> -- http://bsdguy.net - Jesus Christ follower.
>



-- 
-hUgLeO-â