The following reply was made to PR port-amd64/58982; it has been noted
by GNATS.
From: Andrius V <vezhlys%gmail.com@localhost>
To: gnats-bugs%netbsd.org@localhost
Cc:
Subject: Re: port-amd64/58982: NetBSD 10.1 install image (amd64) failed
to
boot on J3455-ITX board (ASRock)
Date: Tue, 21 Jan 2025 21:46:50 +0200
Hi,
On Tue, Jan 21, 2025 at 1:20=E2=80=AFPM
wgstuken%grimme-reitenspezial.de@localhost vi=
a
gnats <gnats-admin%netbsd.org@localhost> wrote:
>
> with the patch to accept other steppings too, the system is coming
up
> now.
>
Thank you for testing, I will request pullup for the changes to
netbsd-10 and netbsd-9.
> There are still some error messages related to CPU initialization,
but I
> was able to install from install-image and boot from hard-disk.
>
> additional failures reported during boot: (all typed in - no copy
paste
> from vga monitor ...)
>
> for all four CPU there is this message:
> acpicpu<n>: autoconfiguration error: failed to add C-state:
AE_SUPPORT
> this message comes twice for each CPU before the C1 setup is
printed for
> CPU0 and before the termal-sensor information is printed for the
others.
>
I believe these are not critical, there's probably possibility to
disable C-states in BIOS as workaround.
>
> acpifan0: autoconfiguration error: failed to initialize
> this is for CPU0 - and there is currently no fan connected ...
>
Likely just a noise because it is really not connected?
> ichsmb0 at cpi0 dev 31 function 1: Intel Apollo Lake SMBus (rev.
0x0d)
> pci_intr_map: no mapping for pin A (line=3Dff)
> cannot set up cpi_intr_handle_t
> ichsmb0: polling
>
> i915drmkms0: notice: Failed to load DMC firmware
> i915/btx_dmx_ver1_07.bin .Disabling runtime power management.
> i915drmkms0: notice: RC6 and powersaving disabled by BIOS
> the order of these two lines differ between boot from usb-stick and
> sata-disk ...
> BIOS setup for grafic is default - nothing changed there.
>
Can't comment on these, some drm errors are quite typical though.
Thanks again!
Regards,
Andrius V