Re: port-amd64/58982: NetBSD 10.1 install image (amd64) failed to boot on J3455-ITX board (ASRock)

["Andrius V via gnats" <gnats-admin%NetBSD.org@localhost>]

The following reply was made to PR port-amd64/58982; it has been noted by GNATS.

From: Andrius V <vezhlys%gmail.com@localhost>
To: gnats-bugs%netbsd.org@localhost
Cc: 
Subject: Re: port-amd64/58982: NetBSD 10.1 install image (amd64) failed to
 boot on J3455-ITX board (ASRock)
Date: Tue, 21 Jan 2025 21:46:50 +0200

 Hi,
 
 On Tue, Jan 21, 2025 at 1:20=E2=80=AFPM wgstuken%grimme-reitenspezial.de@localhost vi=
 a
 gnats <gnats-admin%netbsd.org@localhost> wrote:
 >
 
 >  with the patch to accept other steppings too, the system is coming up
 >  now.
 >
 
 Thank you for testing, I will request pullup for the changes to
 netbsd-10 and netbsd-9.
 
 >  There are still some error messages related to CPU initialization, but I
 >  was able to install from install-image and boot from hard-disk.
 >
 >  additional failures reported during boot: (all typed in - no copy paste
 >  from vga monitor ...)
 >
 >  for all four CPU there is this message:
 >  acpicpu<n>: autoconfiguration error: failed to add C-state: AE_SUPPORT
 >  this message comes twice for each CPU before the C1 setup is printed for
 >  CPU0 and before the termal-sensor information is printed for the others.
 >
 
 I believe these are not critical, there's probably possibility to
 disable C-states in BIOS as workaround.
 
 >
 >  acpifan0: autoconfiguration error: failed to initialize
 >  this is for CPU0 - and there is currently no fan connected ...
 >
 Likely just a noise because it is really not connected?
 
 >  ichsmb0 at cpi0 dev 31 function 1: Intel Apollo Lake SMBus (rev. 0x0d)
 >  pci_intr_map: no mapping for pin A (line=3Dff)
 >  cannot set up cpi_intr_handle_t
 >  ichsmb0: polling
 >
 >  i915drmkms0: notice: Failed to load DMC firmware
 >  i915/btx_dmx_ver1_07.bin .Disabling runtime power management.
 >  i915drmkms0: notice: RC6 and powersaving disabled by BIOS
 >  the order of these two lines differ between boot from usb-stick and
 >  sata-disk ...
 >  BIOS setup for grafic is default - nothing changed there.
 >
 
 Can't comment on these, some drm errors are quite typical though.
 
 Thanks again!
 
 Regards,
 Andrius V