Re: 8.0 rc1 barfs during install

[Kathe <kathe%sdf.org@localhost>]

> From bounces-netbsd-users-owner-kathe=sdf.org%NetBSD.org@localhost Mon May  7 15:50:58 2018
> From: Martin Husemann <martin%duskware.de@localhost>
> To: Kathe <kathe%sdf.org@localhost>
> Cc: netbsd-users%netbsd.org@localhost
> Subject: Re: 8.0 rc1 barfs during install
> Sender: netbsd-users-owner%NetBSD.org@localhost
>
> On Mon, May 07, 2018 at 03:46:33PM +0000, Kathe wrote:
> > i have an amd64 system which runs well with freebsd, openbsd and ubuntu.
> > with netbsd 8.0 rc1, it barfs while outputing the message below;
> > sdhc0: adma error, status ff
> > sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff)
> > sdhc0: command or data phase inhibited
> > sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff)
> > sdhc0: command or data phase inhibited
>
> Could you provide any details?
> Does it hang at that point, just wait for a bit and then continue to boot?
> If possible send the full output of the dmesg command, please.
>
> Martin
>

my system works well with freebsd, openbsd, ubuntu.
under netbsd 8.0 rc1, the following message keeps getting printed;
sdhc0: adma error, status ff
sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff)
sdhc0: command or data phase inhibited
sdhc0: timeout waiting for mask 0x1 value 0 (state=0xffffffff)
sdhc0: command or data phase inhibited
sdhc0: timeout waiting for mask 0x1 value 0 (state=0xffffffff)
sdhc0: command or data phase inhibited
sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff)
sdhc0: command or data phase inhibited
sdmmc0: sdmmc_mem_enable failed with error 60
sdmmc0: couldn't enable card: 60

i can't get to the point of plucking out the dmesg, the message
above keeps getting repeated till the point i power-down the
system.