My guess is that you're going to have to get a video of the screen during installation. On Mon, 7 May 2018, Kathe wrote:
From bounces-netbsd-users-owner-kathe=sdf.org%NetBSD.org@localhost Mon May 7 15:50:58 2018 From: Martin Husemann <martin%duskware.de@localhost> To: Kathe <kathe%sdf.org@localhost> Cc: netbsd-users%netbsd.org@localhost Subject: Re: 8.0 rc1 barfs during install Sender: netbsd-users-owner%NetBSD.org@localhost On Mon, May 07, 2018 at 03:46:33PM +0000, Kathe wrote:i have an amd64 system which runs well with freebsd, openbsd and ubuntu. with netbsd 8.0 rc1, it barfs while outputing the message below; sdhc0: adma error, status ff sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff) sdhc0: command or data phase inhibited sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff) sdhc0: command or data phase inhibitedCould you provide any details? Does it hang at that point, just wait for a bit and then continue to boot? If possible send the full output of the dmesg command, please. Martinmy system works well with freebsd, openbsd, ubuntu. under netbsd 8.0 rc1, the following message keeps getting printed; sdhc0: adma error, status ff sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff) sdhc0: command or data phase inhibited sdhc0: timeout waiting for mask 0x1 value 0 (state=0xffffffff) sdhc0: command or data phase inhibited sdhc0: timeout waiting for mask 0x1 value 0 (state=0xffffffff) sdhc0: command or data phase inhibited sdhc0: timeout waiting for mask 0x3 value 0 (state=0xffffffff) sdhc0: command or data phase inhibited sdmmc0: sdmmc_mem_enable failed with error 60 sdmmc0: couldn't enable card: 60 i can't get to the point of plucking out the dmesg, the message above keeps getting repeated till the point i power-down the system.
-- Hisashi T Fujinaka - htodd%twofifty.com@localhost BSEE + BSChem + BAEnglish + MSCS + $2.50 = coffee