KUROBOX boot dmesg

["Toru Nishimura" <locore64%alkyltechnology.com@localhost>]

Just as an additional data point, KUROBOX is found doing well with
Frank's altboot.

Toru Nishimura / ALKYL Technology

--->8 -------- 8< ---

U-Boot 1.1.4 LiSt 2.1.0 (Sep 21 2006 - 00:22:56) LinkStation / KuroBox

CPU:   MPC8245 Revision 1.4 at 196.608 MHz: 16 kB I-Cache 16 kB D-Cache
DRAM:  64 MB
FLASH:  4 MB
       00  0b  1317  0985  0200  ff
       00  0c  1095  0680  0101  ff
       00  0e  1033  0035  0c03  ff
       00  0e  1033  0035  0c03  ff
       00  0e  1033  00e0  0c03  ff
Net:   COMET#0
stdin :   serial
stdout:   serial
stderr:   serial
IDE:   Bus 0: OK 
 Device 0: Model: Hitachi HDS721680PLAT80 Firm: P21OA8BA Ser#: PV6874ZE04EN1N
           Type: Hard Disk
           Supports 48-bit addressing
           Capacity: 76319.0 MB = 74.5 GB (156301488 x 512)
=> bootp; tftp 1000000 altboot.bin
BOOTP broadcast 1
DHCP client bound to address 192.168.24.66
Using COMET#0 device
TFTP from server 192.168.24.24; our IP address is 192.168.24.66
Filename 'altboot.bin'.
Load address: 0x1000000
Loading: ###############
done
Bytes transferred = 75780 (12804 hex)
=> go 1000000 wd0:/netbsd.5.99.60#3
## Starting application at 0x01000000 ...

> > NetBSD/sandpoint altboot, revision 1.9 (Tue Jan 17 23:40:09 CET 2012)
> > KuroBox, cpu 195 MHz, bus 97 MHz, 64MB SDRAM
channel 0 present
wd0: <Hitachi HDS721680PLAT80> DMA LBA LBA48 76319 MB
wd0a: ffs       (63)
wd0b: swap      (4195359)
wd0d: ffs       (5244687)
MAC address 00:07:40:a4:48:6e
100Mbps-FDX
Hit any key to enter interactive mode: 0
loading "/netbsd.5.99.60#3" 3098708+112796 [197376+191081]=0x36f3a0
entry=0x90000, ssym=0x3a00f0, esym=0x3ff3a0
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
   2006, 2007, 2008, 2009, 2010, 2011, 2012
   The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
   The Regents of the University of California.  All rights reserved.

NetBSD 5.99.60 (KUROBOX) #3: Mon Jan 16 11:27:59 JST 2012
       
nisimura@tpad6:/store/HEAD/build/sandpoint/obj/sys/arch/sandpoint/compile/KUROBOX
Model: kurobox
total memory = 65536 KB
avail memory = 59568 KB
OpenPIC Version 1.2: Supports 1 CPUs and 26 interrupt sources.
mainbus0 (root)
cpu0 at mainbus0: 8245 (Revision 0.4), ID 0 (primary)
cpu0: HID0 0x90c000<DOZE,DPM,ICE,DCE>, powersave: 1
eumb0 at mainbus0
com0 at eumb0 unit 1: ns16550a, working fifo
com0: interrupting at irq 41
ociic0 at eumb0
iic0 at ociic0: I2C bus
rs5c372rtc0 at iic0 addr 0x32: RICOH RS5C372[AB] Real-time Clock
satmgr0 at eumb0 unit 0: button manager (kurobox)
satmgr0: interrupting at irq 40
cfi at mainbus0 not configured
pci0 at mainbus0 bus 0
pchb0 at pci0 dev 0 function 0
pchb0: vendor 0x1057 product 0x0006 (rev. 0x14)
tlp0 at pci0 dev 11 function 0: ADMtek AN985 Ethernet, pass 1.1
tlp0: interrupting at irq 16
tlp0: Ethernet address 00:07:40:a4:48:6e
ukphy0 at tlp0 phy 1: OUI 0x00e092, model 0x0001, rev. 1
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
cmdide0 at pci0 dev 12 function 0: Silicon Image 0680 (rev. 0x02)
cmdide0: primary channel wired to native-PCI mode
cmdide0: using irq 17 for native-PCI interrupt
atabus0 at cmdide0 channel 0
cmdide0: secondary channel wired to native-PCI mode
atabus1 at cmdide0 channel 1
ohci0 at pci0 dev 14 function 0: vendor 0x1033 product 0x0035 (rev. 0x43)
ohci0: interrupting at irq 19
ohci0: OHCI version 1.0
usb0 at ohci0: USB revision 1.0
ohci1 at pci0 dev 14 function 1: vendor 0x1033 product 0x0035 (rev. 0x43)
ohci1: interrupting at irq 19
ohci1: OHCI version 1.0
usb1 at ohci1: USB revision 1.0
ehci0 at pci0 dev 14 function 2: vendor 0x1033 product 0x00e0 (rev. 0x04)
ehci0: interrupting at irq 19
ehci0: companion controllers, 3 ports each: ohci0 ohci1
usb2 at ehci0: USB revision 2.0
biomask 1c000000 netmask 1c000000 ttymask 1c000000
uhub0 at usb0: vendor 0x1033 OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1 at usb1: vendor 0x1033 OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub2 at usb2: vendor 0x1033 EHCI root hub, class 9/0, rev 2.00/1.00, addr 1
wd0 at atabus0 drive 0
wd0: <Hitachi HDS721680PLAT80>
wd0: 76319 MB, 155061 cyl, 16 head, 63 sec, 512 bytes/sect x 156301488 sectors
boot device: wd0
root on wd0a dumps on wd0b
root file system type: ffs
Wed Jan 18 15:08:28 JST 2012
Starting root file system check:
/dev/rwd0a: file system is clean; not checking
swapctl: setting dump device to /dev/wd0b
swapctl: adding /dev/wd0b as swap device at priority 0
Starting file system checks:
/dev/rwd0d: file system is clean; not checking
Setting tty flags.
Setting sysctl variables:
ddb.onpanic: 1 -> 0
Starting network.
Hostname: nas8245
IPv6 mode: host
Configuring network interfaces:.
Adding interface aliases:.
Starting dhclient.
Internet Systems Consortium DHCP Client V3.0.3
Copyright 2004-2005 Internet Systems Consortium.
All rights reserved.
For info, please visit http://www.isc.org/products/DHCP

Listening on BPF/tlp0/00:07:40:a4:48:6e
Sending on   BPF/tlp0/00:07:40:a4:48:6e
Sending on   Socket/fallback
DHCPREQUEST on tlp0 to 255.255.255.255 port 67
DHCPACK from 192.168.24.24
bound to 192.168.24.66 -- renewal in 16261 seconds.
Building databases: dev, utmp, utmpx, services.
Starting syslogd.
Starting rpcbind.
Mounting all filesystems...
Checking quotas: done.
Starting mountd.
Starting nfsd.
Starting statd.
Starting lockd.
Setting securelevel: kern.securelevel: 0 -> 1
swapctl: setting dump device to /dev/wd0b
Starting virecover.
Starting local daemons:.
Updating motd.
Starting xdm.
Starting inetd.
Starting cron.
Wed Jan 18 15:10:20 JST 2012

NetBSD/sandpoint (nas8245) (console)

login: satmgr0: power button pressed, shutting down!
syncing disks... done
unmounting file systems... done

---