Re: Please publish attached draft-ietf-secsh-break-01

[Jeffrey Altman <jaltman%columbia.edu@localhost>]

The receiver of the break signal may behavior differently depending on 
the length of the break.  That is the reason for allowing the value to 
be set.

Jeffrey Altman


Joel N. Weber II wrote:

> It seems like setting the break length in the same place you set the
> baud rate, number of data and stop bits, parity, etc would probably be
> appropriate.  Is there a draft for setting all these other timing
> parameters on a serial port in the ssh protocol that I'm not aware of?

Attachment: smime.p7s
Description: S/MIME Cryptographic Signature